Vibrating Feeder

Working principle
Vibration feeder can be massive, granular materials evenly in the course of their work from the silo, timing, continuously fed by the feeding device, continuous feed is evenly crushed gravel production line machinery, and materials coarse screening.
Stable vibration, reliable, long life; exciting force can be adjusted, subject to change and control the flow, easy to adjust and stable; vibration motor as vibration source, low noise, small power consumption, good adjusting performance, no red material phenomenon.
1. such as a feeder for batching, dosing time, in order to ensure a uniform and stable feeding, to prevent the material gravity should be installed horizontally, such as general material continuous feeding can be installed at 10 ° tilt. For viscous materials and moisture content of the material can be larger at 15 ° tilt installation.
2. after the installation of the feeder should be left travel clearance of 20mm, shall be horizontal transverse suspension devices with flexible connection.
3. before the air again, all bolts should be strong again, especially vibration motor anchor bolts, 3-5 hours of continuous operation, should be re-tightened again.
4. test, two vibration motor must be rotating.
5. for during operation should always check when feed amplitude stability, current and noise, abnormal should promptly stop treatment.
6. motor bearings every two months filling a lubricant, lubricant filling a hot season should be a month.
Technical Parameter:
Belt Width(mm) Belt Length (m) /Power (kw) Belt Speed(m/s) Capacity(t/h)
500 ≤12/3 12-20/4-5.5 20-30/ 5.5-7.5 1.3-1.6 131-323
650 ≤12/4 12-20/5.5 20-30/7.5-11 1.3-1.6 278-546
800 ≤6/4 6-15/5.5 15-30/7.5-15 1.3-1.6 435-853
1000 ≤10/5.5 10-20/7.5-11 20-40/11-12 1.3-2.0 655-1284
1200 ≤10/7.5 10-20/11 20-40/15-30 1.3-2.0 655-1284

Previous:       Next: None